ACRONIS SNAP DEPLOY 3 - FOR WORKSTATION Guide de l'utilisateur télécharger pdf (Page 74)

 By using a bootable media (either Acronis media or WinPE-based media) with Acronis Snap

Deploy 5 Master Image Creator, or by using the command-line utility in a WinPE-based bootable

media. This type of imaging is called offline imaging.

This section describes imaging with Acronis Snap Deploy 5 Management Agent and Acronis Snap

Deploy 5 Master Image Creator. For information about imaging in the command-line mode, see

“Command-line mode and scripting under WinPE” (p. 134).

8.3 Performing online imaging

Online imaging means that the master system is imaged live (without restarting the machine or

suspending operations). Online imaging can be performed remotely whenever you need. The

disadvantage is that you have to install imaging software that is included in the master image. This is

not always rational.

To perform online imaging

1. Install Acronis Snap Deploy 5 Management Console.

2. Configure the master system.

3. Install Acronis Snap Deploy 5 Management Agent on the master system either locally by using

the setup program, or remotely by using Acronis Snap Deploy 5 Management Console. Once

Acronis Snap Deploy 5 Management Agent is installed, you can image the master system online

(without a restart) at any time.

4. Start the Acronis Snap Deploy 5 Management Console.

5. Connect to the master machine.

6. Click Create image -> Next -> A master image.

Tip: The alternative selection, A bootable media, enables you to create a bootable media (p. 65) for offline

imaging (p. 74).

7. Follow the steps of the Master Image Creator wizard (p. 76).

8.4 Performing offline imaging

Offline imaging means that the master system is stopped and the master machine boots into the

Acronis environment or into Windows Preinstallation Environment.

To perform offline imaging

1. Install Acronis Snap Deploy 5 Management Console.

2. Do one of the following:

 Create a bootable media (p. 64) that contains Acronis Snap Deploy 5 Master Image Creator.

 Install Acronis PXE Server, connect the console to the PXE server (p. 71), and upload Acronis

Snap Deploy 5 Master Image Creator. Make sure that network booting is enabled on the

master machine (p. 105).

Tip: While creating the bootable media or uploading Acronis Snap Deploy 5 Master Image Creator to the

PXE server, you can configure the image creator to start automatically after a time-out.

3. Configure the master system.

4. Depending on your choice in step 2, boot the master machine into Acronis Snap Deploy 5 Master

Image Creator from the bootable media or from the PXE server.

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 144 145

Pas de commentaire

ACRONIS SNAP DEPLOY 3 - FOR WORKSTATION Guide de l'utilisateur Page 74